Halfduplex mode function

Half-duplex mode function. More...

Functions
void	USART_HalfDuplexCmd (USART_TypeDef *USARTx, FunctionalState NewState)
	Enables or disables the USART's Half Duplex communication. More...

Detailed Description

Half-duplex mode function.

 ===============================================================================
                         Half-duplex mode function
 ===============================================================================  

  This subsection provides a set of functions allowing to manage the USART 
  Half-duplex communication.
  
  The USART can be configured to follow a single-wire half-duplex protocol where 
  the TX and RX lines are internally connected.

  USART Half duplex communication is possible through the following procedure:
     1. Program the Baud rate, Word length, Stop bits, Parity, Mode transmitter 
        or Mode receiver and hardware flow control values using the USART_Init()
        function.
     2. Configures the USART address using the USART_SetAddress() function.
     3. Enable the USART using the USART_Cmd() function.
     4. Enable the half duplex mode using USART_HalfDuplexCmd() function.


@note The RX pin is no longer used
@note In Half-duplex mode the following bits must be kept cleared:
        - LINEN and CLKEN bits in the USART_CR2 register.
        - SCEN and IREN bits in the USART_CR3 register.

Function Documentation

void USART_HalfDuplexCmd	(	USART_TypeDef *	USARTx,
		FunctionalState	NewState
	)

Enables or disables the USART's Half Duplex communication.

Parameters

USARTx,:	where x can be 1, 2, 3, 4, 5 or 6 to select the USART or UART peripheral.
NewState,:	new state of the USART Communication. This parameter can be: ENABLE or DISABLE.

Return values

None