PVD configuration functions

PVD configuration functions. More...

Functions
void	PWR_PVDLevelConfig (uint32_t PWR_PVDLevel)
	Configures the voltage threshold detected by the Power Voltage Detector(PVD). More...
void	PWR_PVDCmd (FunctionalState NewState)
	Enables or disables the Power Voltage Detector(PVD). More...

Detailed Description

PVD configuration functions.

 ===============================================================================
                           PVD configuration functions
 ===============================================================================  

 - The PVD is used to monitor the VDD power supply by comparing it to a threshold
   selected by the PVD Level (PLS[2:0] bits in the PWR_CR).
 - A PVDO flag is available to indicate if VDD/VDDA is higher or lower than the 
   PVD threshold. This event is internally connected to the EXTI line16
   and can generate an interrupt if enabled through the EXTI registers.
 - The PVD is stopped in Standby mode.

Function Documentation

void PWR_PVDCmd

(

FunctionalState

NewState

)

Enables or disables the Power Voltage Detector(PVD).

Parameters

NewState,:

new state of the PVD. This parameter can be: ENABLE or DISABLE.

Return values

None

void PWR_PVDLevelConfig

(

uint32_t

PWR_PVDLevel

)

Configures the voltage threshold detected by the Power Voltage Detector(PVD).

Parameters

PWR_PVDLevel,:

specifies the PVD detection level This parameter can be one of the following values: PWR_PVDLevel_0 PWR_PVDLevel_1 PWR_PVDLevel_2 PWR_PVDLevel_3 PWR_PVDLevel_4 PWR_PVDLevel_5 PWR_PVDLevel_6 PWR_PVDLevel_7

Note

Refer to the electrical characteristics of your device datasheet for more details about the voltage threshold corresponding to each detection level.

Return values

None