Configuration of the CRC computation unit functions.
More...
Configuration of the CRC computation unit functions.
===============================================================================
##### CRC configuration functions #####
===============================================================================
Deinitializes CRC peripheral registers to their default reset values.
- Parameters
-
- Return values
-
void CRC_PolynomialSizeSelect |
( |
uint32_t |
CRC_PolSize | ) |
|
Selects the polynomial size.
- Parameters
-
CRC_PolSize,: | Specifies the polynomial size. This parameter can be:
- CRC_PolSize_7: 7-bit polynomial for CRC calculation
- CRC_PolSize_8: 8-bit polynomial for CRC calculation
- CRC_PolSize_16: 16-bit polynomial for CRC calculation
- CRC_PolSize_32: 32-bit polynomial for CRC calculation
|
- Return values
-
void CRC_ResetDR |
( |
void |
| ) |
|
Resets the CRC calculation unit and sets INIT register content in DR register.
- Parameters
-
- Return values
-
void CRC_ReverseInputDataSelect |
( |
uint32_t |
CRC_ReverseInputData | ) |
|
Selects the reverse operation to be performed on input data.
- Parameters
-
CRC_ReverseInputData,: | Specifies the reverse operation on input data. This parameter can be:
- CRC_ReverseInputData_No: No reverse operation is performed
- CRC_ReverseInputData_8bits: reverse operation performed on 8 bits
- CRC_ReverseInputData_16bits: reverse operation performed on 16 bits
- CRC_ReverseInputData_32bits: reverse operation performed on 32 bits
|
- Return values
-
void CRC_ReverseOutputDataCmd |
( |
FunctionalState |
NewState | ) |
|
Enables or disable the reverse operation on output data. The reverse operation on output data is performed on 32-bit.
- Parameters
-
NewState,: | new state of the reverse operation on output data. This parameter can be: ENABLE or DISABLE. |
- Return values
-
void CRC_SetInitRegister |
( |
uint32_t |
CRC_InitValue | ) |
|
Initializes the INIT register.
- Note
- After resetting CRC calculation unit, CRC_InitValue is stored in DR register
- Parameters
-
CRC_InitValue,: | Programmable initial CRC value |
- Return values
-
void CRC_SetPolynomial |
( |
uint32_t |
CRC_Pol | ) |
|
Initializes the polynomail coefficients.
- Parameters
-
CRC_Pol,: | Polynomial to be used for CRC calculation. |
- Return values
-