Backup Regulator configuration functions

Backup Regulator configuration functions. More...

Functions
void	PWR_BackupRegulatorCmd (FunctionalState NewState)
	Enables or disables the Backup Regulator. More...

Detailed Description

Backup Regulator configuration functions.

 ===============================================================================
                    Backup Regulator configuration functions
 ===============================================================================  

 - The backup domain includes 4 Kbytes of backup SRAM accessible only from the 
   CPU, and address in 32-bit, 16-bit or 8-bit mode. Its content is retained 
   even in Standby or VBAT mode when the low power backup regulator is enabled. 
   It can be considered as an internal EEPROM when VBAT is always present.
   You can use the PWR_BackupRegulatorCmd() function to enable the low power
   backup regulator and use the PWR_GetFlagStatus(PWR_FLAG_BRR) to check if it is
   ready or not. 

 - When the backup domain is supplied by VDD (analog switch connected to VDD) 
   the backup SRAM is powered from VDD which replaces the VBAT power supply to 
   save battery life.

 - The backup SRAM is not mass erased by an tamper event. It is read protected 
   to prevent confidential data, such as cryptographic private key, from being 
   accessed. The backup SRAM can be erased only through the Flash interface when
   a protection level change from level 1 to level 0 is requested. 
   Refer to the description of Read protection (RDP) in the Flash programming manual.

Function Documentation

void PWR_BackupRegulatorCmd

(

FunctionalState

NewState

)

Enables or disables the Backup Regulator.

Parameters

NewState,:

new state of the Backup Regulator. This parameter can be: ENABLE or DISABLE.

Return values

None